Wall Switch not included

See Note at Right 

More than one lamp can be operated from a single wall switch, however each lamp requires its own Electronic Ignition Component.  It is recommended that every 2 lights have a separate transformer.

Builders and Home Owners are welcome to phone for technical support regarding installation information.  We're ready to assist you!

Electronic Ignition System

Approved for both Indoor & Outdoor usage!

Control your Gas Light with the flip of a Switch!

The electronic ignition system allows open-flame lanterns to be turned on with a typical light switch (not included).  With electronic ignition, should the flame blow out, the lantern will automatically re-ignite.  Customers now have the convenience of turning the gas lantern on and off with the flip of a switch rather than with lighters and ladders.  

The electronic ignition system can be used for situations where gas lanterns are installed over doors, or where ladders are needed to turn lights on and off.  It can also be useful in conservation of energy, where lanterns are not wanted to burn continuously.

If the electricity or the gas service is interrupted, the flame extinguishes and stays off until the service is resumed, and the flame will automatically re-ignite.  At no time is the unignited gas flow allowed to continue more than the few seconds it takes for the igniter to start the flame.  

The system is comprised of three different components; valve, control box and igniter.  Specifications accompany each lantern purchased with this option.

The electronic ignition valve has 1/4" female international pipe thread (F.I.P.) connection.  The power source operating the electronics is 24 V.A.C. 40VA.  Transformers supplied by the customer.

NOT SOLD SEPARATELY

Only with purchase of Legendary Lighting or Copper Sculptures Gas Lights.